What are the faults of the ice crusher and how to repair it? Find out in one article!

As soon as summer comes, ice cream has become a favorite of many people. After all, how wonderful would it be to have a taste of ice in the hot weather? It is precisely because of this that ice crushers have become quite popular. After all, sometimes the ice cubes are relatively large. Although they are convenient for preserving food, they may be too bulky if they are to be eaten. But in the summer, the usage rate of the ice crusher increases greatly, and malfunctions are inevitable. How to repair it specifically? You can take a look at how Hong Kong Junhong electrical repairs are handled, and you will know in one article.

1. The ice machine compressor is working normally, but it cannot make or remove ice.

1. You need to check first to see if there is a risk of leakage, or the seal at the interface may not be very strong. If it is these problems, just shut it off directly. If necessary, you need to add refrigeration night or replace the solenoid valve, so that the problem can be solved.

2. If you find that there are no problems as mentioned above, but you cannot remove ice, it may be that the thermometer is wrong, or it may be that the intelligent system cannot sense the water temperature, causing an error in the entire system. Unable to enter de-icing program. You need to measure the temperature with a multimeter first and then determine the resistance. Just find the store with the problem and replace or adjust it.

3. It is also possible that the solenoid valve is damaged, resulting in the inability to de-ice normally. Just replace the outer coil or solenoid valve. But operation requires professional maintenance team support. The technicians at Junhong Electrical Repair in Hong Kong are good at using multimeters to find the problem immediately.

2. The ice machine shows that it is short of water, but the equipment does not automatically replenish water or the water pump does not work.

1. There are two main reasons for water shortage. The first reason is that there is no water at the source, resulting in the inability to enter the water. It's also because the water inlet solenoid valve is faulty. You can check it by restarting. If there is a water source and you restart, but water still cannot enter, then the water inlet solenoid valve needs to be repaired.

2. The water pump is damaged or there is a lot of dirt in the pump, which will cause blockage and eventually damage the water pump. This requires direct replacement of the water pump.

Three, no ice

The reason why there is no ice may be that the thermometer is malfunctioning, resulting in temperature imbalance and the inability to make ice normally. It may also be caused by insufficient Freon or blockage of the Freon channel. Just check and repair.

Some time ago, Hong Kong Junhong Electrical Maintenance encountered a case of repairing the Baijie ice crusher, which was due to the failure of the equipment not freezing. Therefore, the maintenance master here reminds you to remember to perform daily maintenance and inspections, so as to avoid Get rid of most of the malfunction problems!